Hebei Xugong Kunpeng Wuxi Branch

HOT PRODUCTS:

TEL:15351685709

XC938-EV

  consultation

For specific preferential policies, please call 15351685709



Product Introduction
Walking motor
Adopting a single motor walking drive technology, the entire machine walking system adopts a single motor, which is connected to the drive bridge through a transmission shaft to optimize power matching, allowing the entire machine to have greater torque output and faster response speed.
The motor adjusts its speed in real-time based on the throttle opening, achieving stepless speed change of the entire machine.

Drive axle
Adopting XCMG's self-made reinforced drive axle, the axle housing is optimized in design, with a larger cross-section of the housing, and a 10% increase in load-bearing capacity and bending resistance.
Strong construction machinery transmission shaft, strong impact resistance, and high reliability of power transmission.
Key structural components are subjected to finite element analysis to reduce stress concentration, eliminate local weaknesses, and ensure compliance with various harsh working conditions.
The front and rear frames are designed with heavy loads, thick steel plates, high strength, and strong load-bearing capacity.
Reasonable layout, concise structure, reduced compression and irregular welds, strengthened important load-bearing parts, and able to withstand torque and impact loads under various working conditions.
Increasing the distance between the upper and lower hinge pins at the hinge center, dispersing the force at the hinge joint, can reduce the stress on the hinge pin and improve the service life of the bearing.
The working device has been optimized and designed with a Z-shaped reverse six link structure consisting of a single rocker arm, a short pull rod, and a horizontal boom cylinder. It has low unloading impact and superior operational performance and efficiency.
The main hinge point adopts a two-stage dust-proof structure, which can effectively prevent dust and protect the lubricating grease from contamination, providing reliable protection for the hinge pin and shaft sleeve.
The main parts of the bucket that are prone to wear are made of wear-resistant plates, and the bucket has a long service life.
XCMG's new micro turbocharged cab has a large space, wide field of view, and good sealing.
The use of high-performance shock absorbers connected to the frame greatly reduces cab vibration.
Mechanical shock absorption composite control seat, comfortable to operate.
Intelligent temperature control high-power heating and cooling air conditioning with suitable operating temperature.

Product selling points
XC938-EV electric loader optional 1.8-3.0 m ³  Series of buckets, wooden pliers, grass grabbing machines and quick change tools, etc.
XCMG's new micro turbocharged cab has a large space, wide field of view, and good sealing.
Adopting a single pump diversion quantitative hydraulic system, the working device is pilot controlled, and the operation is accurate and lightweight.
Key structural components are subjected to finite element analysis to reduce stress concentration, eliminate local weaknesses, and ensure compliance with various harsh working conditions.

Parameter configuration
project unit XC938-EV
Rated load capacity kg 3500
Rated power kW 156
Overall weight kg 11650±200
Unloading height mm 3120
Maximum digging force kN 105±5


PREV:XC975
NEXT:XC958-EV

SCAN WAP SITE

Copy right ? 2020 Hebei Xugong Kunpeng Engineering Machinery Co., Ltd. Wuxi Branch